Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Kitchen Remodeling: The Fort Lauderdale Owner’s Guide
A full KraftMaid kitchen remodel in Fort Lauderdale typically runs $14,000 to $45,000 installed, depending on cabinet count, countertop material, and whether walls or plumbing move. If you’re here because a hinge is sagging, a drawer slide snapped, or a door won’t stay shut on your KraftMaid cabinets, that’s a different, smaller job, and it’s one we handle just as seriously. Most homeowners discover something’s wrong when a drawer starts grinding, a door leaves a gap at the top, or a cabinet box pulls away from the wall in a house that’s been through a few humid South Florida summers.
KraftMaid cabinets are built well, but Fort Lauderdale’s salt air and humidity stress wood and hardware in ways a dry climate never will. Drawer slides collect grit, hinges lose their spring, and laminate edges start lifting after years of moisture cycling. Replacing the failed part and keeping the rest of the kitchen intact is usually the smartest move, and that’s exactly what we do as an independent remodeling contractor, not a KraftMaid dealer. We’re Sawyer Remodel Fort Lauderdale, and we’ve been running jobs under The Relay Standard since 2005.
Key Takeaways
- Fort Lauderdale KraftMaid kitchen remodels: $14,000 – $45,000 installed
- Individual cabinet part replacements (hinges, slides, doors): typically $150 – $600 per cabinet, parts plus labor
- We stock common KraftMaid hinge and slide replacements on the truck
- Written price before any work starts. Always.
- Humidity and salt air shorten hardware life here by roughly 3 – 5 years compared to inland climates
Which KraftMaid Models This Applies To
KraftMaid has built cabinets under several lines over the years, and the hardware specs aren’t always interchangeable between them. The older KraftMaid Classic and KraftMaid Passport lines used a different hinge mounting pattern than the newer Vantage and Venicia series. If you have a cabinet from roughly 2015 or later, you’re likely looking at 35mm cup hinges with soft-close dampers. Earlier cabinets often used 26mm cups, and pulling a hinge off the door to measure the cup diameter is the single fastest way to confirm what you need.
Here’s what to check before you order anything: the hinge cup diameter, the hinge overlay (how far the door overlaps the frame, usually 1/2 inch or 1-1/4 inch), and whether the drawer slides are side-mounted or under-mounted. KraftMaid under-mount slides from the Vantage era are 3/4 extension unless the original buyer upgraded to full extension. Mixing these up means drawers that stick halfway or doors that won’t close flush. On cabinet boxes themselves, look for a stamp or label inside the sink base cabinet door frame. KraftMaid prints the cabinet code there, and that code tells you the door style, finish, and hinge spec. That label saves a lot of guesswork, and it’s usually still legible even after a decade.
OEM versus aftermarket is a real decision for KraftMaid owners. OEM hinges and slides from a KraftMaid dealer match exactly, but lead times can stretch to two or three weeks. Quality aftermarket hardware from Blum, Salice, or Hettich usually fits the same 35mm cup and performs as well or better, especially if you want soft-close on an older door that never had it. In a kitchen near Las Olas or Victoria Park with original 2000s cabinetry, we frequently swap tired builder hinges for Blum soft-close units. The doors close like new, and nobody has to order a single cabinet.
Styles & brands we work with
Signs Your KraftMaid Kitchen Remodeling Is Failing
- Sagging or crooked doors: The hinge screws have stripped out of the face frame or the hinge itself has worn at the pivot. In Fort Lauderdale humidity, MDF face frames soften over time, and screws lose their bite. We fix this by re-tapping with threaded inserts, not just driving a longer screw into mush.
- Drawers that grind or catch: The ball bearings in the slide are dry, corroded, or full of cooking grease and salt air residue. Once a slide starts grinding, lubricating rarely fixes it. The track’s plastic roller has usually flattened or cracked.
- Doors that won’t stay shut: The catch or the soft-close damper has failed. KraftMaid’s older dampers are plastic, and they crack after years of slamming. The door then bounces open or hangs slightly ajar.
- Delaminating or peeling laminate: Moisture has worked its way into the thermofoil or laminate edge, especially near the dishwasher, sink, or any cabinet that faces a window. Once it starts peeling, the only real fix is a new door or drawer front, matched to the existing finish.
- Cabinet box pulling from the wall: The wall anchors or screws have failed, often because the house settled or the original installer hit drywall instead of a stud. A heavy stack of upper cabinets slowly leaning forward is a problem you don’t wait on.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A single cabinet door hinge or drawer slide replacement in Fort Lauderdale runs $150 – $600 per cabinet, including the part, removing the old hardware, installing the new, and adjusting the door or drawer so it sits square. Replacing a full door or drawer front typically runs $90 – $300 per front, depending on style and finish matching. A complete KraftMaid kitchen remodel, which means new or refaced cabinets, countertops, and usually a backsplash, runs $14,000 – $45,000.
What drives the range? Cabinet count is the biggest variable. A galley kitchen in a condo near Galt Ocean Mile has maybe 12 – 14 cabinet openings. A full kitchen in a 4-bedroom house in Coral Ridge or Imperial Point can have 30-plus. Then add countertop material: a basic quartz runs less than Cambria or Caesarstone, and any natural stone pushes the total up. The price we give you is written down before we pick up a tool, and the number on the invoice is the number you approved. Our 365-Day Done Right Promise covers the work for a full year. If a hinge we installed fails, we come back and fix it. Written guarantee, every job.
DIY or Call Us?
Replacing a KraftMaid hinge is genuinely doable if you have a drill and a patient afternoon. The cup screws go into the door back, the base plate screws into the face frame, and there’s an adjustment screw for fore-aft and side-to-side. Where DIY goes sideways is when the old screws spin in stripped holes, when the overlay measurement was wrong, or when a drawer slide needs a new mounting block because the cabinet box has swollen with moisture. That last one is common in older Fort Lauderdale homes with original 1980s cabinets, and the fix is a re-shim job, not a hardware swap.
Cabinet box separation from the wall is not a DIY job. Upper cabinets are heavy, and if the anchors have failed, you don’t want one coming down on someone’s head. Same goes for any repair that involves removing a large upper cabinet or working around live plumbing under the sink. Call (754) 354-7423 and we’ll come look. The estimate is free, the price is written, and Luca Romano or one of our background-checked, uniformed techs will be the one at your door.
FAQs
KraftMaid cabinet boxes can last 25 – 30 years if they stay dry, but hinges and drawer slides in Fort Lauderdale’s humidity typically last 10 – 15 years before they need replacement. Coastal salt air accelerates corrosion on the metal parts even indoors. Call (754) 354-7423 for a free inspection and a written estimate to replace what’s worn.
A stripped face frame screw hole can be repaired with a threaded insert, but a bent or corroded hinge or a slide with a flattened roller is a replace, not a repair. The cost difference is small enough that most owners choose new hardware. Call (754) 354-7423 and we’ll tell you straight which category your part falls into.
A single hinge or drawer slide replacement takes 30 – 60 minutes on site. A full kitchen’s worth of hinge and slide swaps usually takes half a day. If we’re refacing doors or replacing cabinet boxes, that’s a 2 – 5 day project depending on kitchen size. We’ll give you a written timeline with your written price.
Our trucks carry common 35mm soft-close hinges, Blum slides, mounting plates, and threaded inserts on most service days. Unusual sizes or specific KraftMaid finish-matched door fronts typically take 1 – 2 weeks to order. We’ll tell you which applies to your job before you commit to anything. Call (754) 354-7423 for availability on your specific part.
If your KraftMaid kitchen is showing its age, start with the cabinets. We also work alongside Cambria, Silestone, and Kohler products in full kitchen remodels, so the whole room goes together under one written price and one team. The work either holds up or it doesn’t – we make sure it does.
Written by Luca Romano, Owner & Lead Contractor, Sawyer Remodel Fort Lauderdale at Sawyer Remodel Fort Lauderdale, serving Fort Lauderdale and nearby areas.
