Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Moen Bathroom Remodeling: The Fort Lauderdale Owner’s Guide
A full Moen bathroom remodel in Fort Lauderdale runs $9,000 to $28,000 installed, depending on whether you’re swapping a faucet and trim or gutting the whole room down to studs. We stock Moen fixtures, cartridges, trim kits, and shower valves and can start most Moen-focused remodels within a week of your estimate. The giveaway that a Moen part has failed is usually a drip that won’t stop, a handle that spins loose, or water temperature that swings hot and cold no matter how carefully you adjust it.
We’re an independent remodeling contractor serving Fort Lauderdale, not a Moen subsidiary, which means we match your existing Moen product to the right OEM or quality aftermarket part, then install it right the first time. If you’re staring at a corroded cartridge or a leaking shower valve, the fix usually sits somewhere between a $200 parts swap and a $28,000 full bathroom rebuild, depending on what else we find behind the wall.
Which Moen Models This Applies To
Moen’s bathroom lineup splits into a few compatibility families that matter when you’re replacing parts. The biggest gotcha: a Moen posi-temp valve (used on most tub/shower combos from the last 25 years) will not accept a Moentrol trim kit, even though both look nearly identical on the shelf. They use different cartridges, different escutcheons, and different rough-in valves. If you bring us a trim kit you bought online and it doesn’t match the valve behind your wall, we’ll tell you straight before we open anything permanent.
Here’s what we work with daily across Fort Lauderdale bathrooms: Moen posi-temp shower valves (pressure-balancing, the most common), Moentrol valves (two-handle temperature and volume, found in older condos near Las Olas Boulevard and Victoria Park), M-CORE valves (Moen’s current generation, used in newer builds across Flagler Village and Rio Vista), and the newer Moen Flo and Smart Shower digital systems. For faucets, we see a lot of the Brantford, Align, and Genta lines, plus the older Kingsley and Castleby faucets that predate Moen’s current naming.
On the OEM-versus-aftermarket question, here’s our honest position: for anything inside the wall, like a shower valve or a cartridge, we recommend genuine Moen parts. The tolerances are tighter and Moen’s lifetime warranty covers the part when we install it. For trim, escutcheons, tub spouts, and shower heads, a quality aftermarket equivalent (Danco and BrassCraft make reliable Moen-compatible replacements) often works fine and saves you 20 – 40%. We’ll quote both options and let you pick.
Styles & brands we work with
Signs Your Moen Bathroom Remodeling Is Failing
- Dripping tub spout or shower head that persists after you shut the water off tightly. This is almost always a worn posi-temp cartridge or a failing Moentrol O-ring. In Fort Lauderdale’s hard water, mineral scale accelerates cartridge wear, and we replace these at least once a week.
- Handle spins freely or catches mid-turn. The brass adapter behind the handle has stripped, or the cartridge stem has rounded. It’s a small parts fix, but waiting makes the valve body itself wear out, which turns a $100 repair into a $1,000 wall opening.
- Temperature swings hot-to-cold without touching the handle. The pressure-balancing spool inside the cartridge has seized on one side. This is more common in Fort Lauderdale than people realize because the city’s aging water lines run inconsistent pressure between the hot and cold supply.
- Water leaking from behind the escutcheon plate, not from the spout. The valve body has a crack, or the stops behind the valve have failed. This is wall damage waiting to happen, especially in older Fort Lauderdale homes with drywall that’s already soft from humidity.
- Low water flow from the shower head only, while the tub spout runs full pressure. The diverter gate on the Moen tub spout has worn down. A replacement spout runs about $30 to $60 in parts, and it’s a 20-minute fix if caught early.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest pricing picture for Moen-specific bathroom work in Fort Lauderdale. A straightforward cartridge or trim replacement runs $200 to $500 installed, including the part. A shower valve replacement, where we open the wall, swap the rough-in, and re-seal everything with proper waterproofing, runs $800 to $2,000 depending on whether we’re replacing tile or using a remodel plate. A full Moen bathroom remodel, meaning valve, trim, tub or shower base, tile, vanity, lighting, and fixture package, lands between $9,000 and $28,000.
What drives that range: the size of the bathroom, whether you’re moving plumbing or keeping it in the same wall, the tile grade you choose, and whether we find rot or mold behind the existing surround. A 5-by-8 standard hall bath in Fort Lauderdale with Moen Align fixtures, a 60-inch tub, and mid-grade porcelain tile usually lands around $14,000 to $18,000. A smaller 5-by-5 bath with a curbless shower and M-CORE valve usually sits closer to $11,000 to $14,000. Every quote includes the written parts line, the labor line, and our 365-Day Done Right Promise: if the work doesn’t hold up, we come back and fix it at no charge for a full year.
DIY or Call Us?
Some Moen parts are genuinely safe to replace yourself. A tub spout unscrews and screws back on. A shower head swaps in ten minutes with a wrench. An escutcheon plate pops off and re-seats with plumber’s putty behind it. If you’re just refreshing trim, go for it. Moen’s lifetime warranty will even send you replacement parts if you register the original purchase and file a claim.
The line to stop at is anything behind the escutcheon or inside the valve body. Removing a posi-temp cartridge requires a Moen cartridge puller tool, and forcing the cartridge out with pliers scores the brass valve body, which ruins the whole rough-in and turns a $40 fix into a $1,500 wall replacement. Same goes for any work that involves shutting off your main water line in a Fort Lauderdale condo, where shared shut-offs mean one wrong valve affects your neighbors. If you’re unsure, call (754) 354-7423 and describe what you’re seeing. We’ll tell you over the phone if it’s a DIY job or if you should leave it to us.
FAQs
Moen cartridges typically last 8 to 12 years in Fort Lauderdale’s hard water, which is 2 to 4 years shorter than the national average because mineral deposits from the Biscayne Aquifer wear on brass and rubber seals. Faucet bodies and valve bodies themselves can last 20 to 30 years if the cartridge is swapped on schedule. Give us a call at (754) 354-7423 and we’ll help you figure out if your fixture is worth saving or due for a replacement.
Yes, and that’s usually the right move. A Moen cartridge runs about $40 to $60 for the part, and we install it for our standard service rate in Fort Lauderdale. Replacing the whole fixture only makes sense if the valve body is cracked, the brass fittings are stripped, or you want a new finish and trim style anyway. Call (754) 354-7423 for an honest read on which path fits your situation.
Most Moen valve replacements take one day from start to finish, including opening the wall, swapping the rough-in, waterproofing, patching, and re-installing trim. If tile replacement is involved around the valve opening, plan on two days. We’ll give you a written timeline before work starts so there are no surprises on the schedule.
We keep the most common Moen parts on our trucks: posi-temp cartridges, Moentrol cartridges, tub spouts, shower heads, escutcheons, and trim screws. Uncommon finishes or model-specific trim kits may need a 2 to 5 day order from our supplier. Call (754) 354-7423 with your model number and we’ll check stock before you book.
The work either holds up or it doesn’t, and we make sure it does. Luca Romano and the Sawyer Remodel Fort Lauderdale team have been fixing and remodeling bathrooms across this city long enough to know that the difference between a bad Moen repair and a good one is usually patience: matching the right part, standing behind the install, and showing up when we say we will.
If your Moen bathroom fixtures are giving you trouble, or you’re ready to gut the whole room and rebuild it with Moen fixtures from the valve out, call us at (754) 354-7423 for a free written estimate. We’ll tell you what it costs, what it’ll take, and when we can start.
Written by Luca Romano, Owner & Lead Contractor, Sawyer Remodel Fort Lauderdale at Sawyer Remodel Fort Lauderdale, serving Fort Lauderdale and nearby areas.
