Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ViewLux Roofing: The Fort Lauderdale Owner’s Guide
ViewLux skylight and roof window repair in Fort Lauderdale typically runs $400 – $1,800 installed, depending on whether we’re replacing a flashing kit, a curb-mount seal, or the full unit. We stock ViewLux-compatible flashing, gaskets, and hardware on our trucks, so most calls end with the part swapped and the leak stopped the same day. Most owners discover a failing ViewLux unit the way you’d expect here: a water stain on the ceiling, a drip during an afternoon downpour, or condensation between the panes that never clears. By the time any of that shows up, the seal or flashing has been compromised for a while.
We’re an independent contractor, not a ViewLux dealer or affiliate. That means we match parts to your unit without pushing a brand upgrade you don’t need.
Key Takeaways:
- ViewLux roof windows fail most often at the flashing, not the glass
- Fort Lauderdale’s salt air and UV turn ten-year seals into five-year seals
- We carry flashing kits, curb seals, and dome replacements for most ViewLux series
- Written price before any work starts, every time
Which ViewLux Models This Applies To
ViewLux has produced several series over the years, and the part you need depends on which one is up there. The older ViewLux fixed skylights (often curb-mounted, manual vent or fixed glass) take a different flashing profile than the newer deck-mounted roof windows with integrated insulation collars. If you can reach the frame, look for the label etched on the interior side of the sash or printed on the aluminum frame near the hinge. The label carries the series code, the glass spec, and the production date. If the label is faded or gone, we measure the rough opening, the curb height, and the glass thickness on site. A 22-inch by 22-inch curb-mounted unit from the early 2000s is not a 22-by-22 deck-mounted unit from 2019, even though both say ViewLux on them. They use different flashing.
On the OEM versus aftermarket question: ViewLux OEM flashing kits and gaskets are still available for most series and cost more. Quality aftermarket flashing from a supplier like Oatey or Tite-Seal works fine on most deck-mounted and curb-mounted applications, and we use it regularly. But for dome replacements on older fixed units, we recommend the OEM dome when it’s available, because the aftermarket acrylics tend to yellow faster under Fort Lauderdale’s UV. That’s a real cost-versus-lifespan trade-off we’ll walk through with you before you spend a dollar.
Styles & brands we work with
Signs Your ViewLux Roofing Is Failing
- Water staining around the ceiling opening. This means the flashing or curb seal has opened up and rain is getting between the roof deck and the skylight frame. In Fort Lauderdale, heavy afternoon storms can make this show up months after the actual failure.
- Condensation between the panes. The insulated glass unit has lost its gas fill or its secondary seal. You can’t wipe it away, and it won’t go away on its own. The glass unit needs replacement.
- Visible cracks or clouding in an acrylic dome. Older ViewLux domes are single-layer acrylic. Salt air and sun here leave them pitted, hazy, and eventually cracked. Once you see a stress crack, replacement is the only fix.
- Wood rot or soft drywall around the interior frame. This is a slow leak, not a dramatic one. By the time you can push your thumb into the drywall, the framing underneath probably took water for a season or two.
- You can hear wind or feel air movement near the closed unit. The gasket has compressed or the sash is out of square. That draft means the seal is not doing its job, and the first big storm will find its way through.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Fort Lauderdale, ViewLux roofing repair work falls into a few common bands:
| Job | Typical Installed Range |
|---|---|
| Flashing kit replacement or reseal | $400 – $900 |
| Curb seal / gasket replacement | $350 – $700 |
| Dome or glass unit replacement | $600 – $1,500 |
| Full unit swap (new skylight, new flashing) | $1,200 – $1,800 |
What drives the range is access. A single-story roof with a shallow pitch is a fast job. A two-story with tile roofing around the curb takes longer, and the tile work has to be cut and reseated properly. Every quote includes parts, labor, cleanup, and the written warranty on our work. We don’t do “parts-only” surprises or add change orders at the end. The price you approve before we start is the price on the invoice.
DIY or Call Us?
Here’s the honest split. You can absolutely check your interior ceiling for staining, inspect the glass for cracks, and look for visible gaps in the framing from inside the house. Those are safe, useful checks. What you should not do is get on a roof in Fort Lauderdale without fall protection and a spotter, especially a tile roof that’s wet from morning dew. Removing and reseating flashing means cutting into the existing roof covering, re-bedding tiles, and getting the seal plane right the first time. A missed step there leaks worse than the original problem. And if your unit is high-tension vented with a manual operator or a motorized sash, let us handle the mechanism, too.
If you’ve got a stain spreading or a crack you can see from the inside, call (754) 354-7423. We’ll come out, look it over, and give you a written price before any work begins.
FAQs
In Fort Lauderdale, expect 10 to 15 years from the flashing and seals on a well-installed ViewLux unit, not the 20-plus you might hear for northern climates, because salt air and intense UV shorten the sealant and gasket life here. The glass itself can last much longer if the seals hold. If your unit is past 12 years old and showing signs of leakage, replacement of the flashing and gaskets is usually the right call. Call (754) 354-7423 and we’ll inspect it for free.
Yes, most ViewLux failures are repairable, especially flashing leaks, failed gaskets, and single-pane dome cracks. The only time we recommend full replacement is when the frame is rotted at the curb, the insulated glass unit is fogged beyond recovery, or the original unit was installed incorrectly. We’ll tell you straight if a repair doesn’t make sense. Call (754) 354-7423 and we’ll walk through your options.
Most flashing, seal, and gasket replacements take two to four hours on site, including removing the old material, prepping the curb, installing the new part, and reseating any tile or shingles around it. A full unit swap can take most of a day depending on access and roof pitch. We’ll give you a time window before we start, not after.
We carry standard ViewLux flashing kits, curb seals, gaskets, and common dome sizes in our Fort Lauderdale service trucks, so many repairs happen in one visit. If your unit needs a less common glass spec or a specific series part, we order it and have it in hand within about a week. Either way, you get the written price before we touch anything.
Written by Luca Romano, Owner & Lead Contractor, Sawyer Remodel Fort Lauderdale at Sawyer Remodel Fort Lauderdale, serving Fort Lauderdale and nearby areas.
